Steady Install: Tools For Each Level

 

General Information For Tools:

Steady Install ranks it’s workers into 4 levels based on their years of relevant experience and the tools they would be bringing. Level 1s and Level 2s are required to bring what we call ‘FULL TOOLS,’ Level 3s are required to bring what we call ‘BASIC TOOLS,’ and Level 4s are not required to bring any tools, which is why Level 4s are typically used for manual labor needs. In the event a project requires any items not listed below, they would need to added as additional Site Requirements to the project.

FULL TOOLS

The Full Tools list is mandatory for both the Level 1 (Expert) and Level 2 (Senior) workers:

  1. Adjustable Pliers
  2. Allen Plusters (standard and metric)
  3. Bit magnetizer
  4. Box knife with extra blades
  5. Commercial Grade Drill - 12 volt or higher (Ryobi, Makita, Rigid,
  6. Milwaukee, Hitachi, Bosch, DeWalt, Hilti)
  7. Commercial Grade Level, 12"
  8. Drill Batteries and Charger (2)
  9. Drill Bit Set, up to 1/2inch
  10. Electrical Tester
  11. Hack saw and blades
  12. Magnetic bit holder, 6 inch
  13. Magnetic bit holders, 2 inch (at least 2)
  14. Philips # 2 tips for magnetic bit holder (at least 6)
  15. Philips #2, 2 inch (at least 2)
  16. Philips #2, 6 inch (at least 2)
  17. Philips #3, 2 inch (at least 2)
  18. Point socket, 3/8" 12
  19. Pry Bar
  20. Ratchet Wrench 3/8"
  21. Robertson (square) #1,#2, and #3 tips (min 2 of each)
  22. Rubber mallet/hammer (not black)
  23. Set of Allen bits for ratchet up to 3/8"
  24. Set of standard deep sockets up to ¾"
  25. Set of Torx bits (T10-T45)
  26. Snips
  27. Spackle knife (metal end)
  28. Spade bit, ½ inch
  29. Tape measure, 25’ or more
  30. Tool box/bag big enough to hold all above tools

Full PPE Available Upon Request (check off during project creation):

  • OSHA approved gloves
  • OSHA approved hard hat
  • OSHA approved safety glasses
  • OSHA approved vest
  • Steel or Composite Toe Boots

BASIC TOOLS

The Basic Tools list is mandatory for the Level 3 (Intermediate) workers:

  1. Box knife with extra blades
  2. Commercial Grade Drill - 12 volt or higher (Ryobi, Makita, Rigid, Milwaukee, Hitachi, Bosch, DeWalt, Hilti)
  3. Commercial Grade Level 12"
  4. Drill Batteries and Charger (2)
  5. Drill Bit Set, up to 1/2inch
  6. Philips #2, 6 inch (at least 2)
  7. Pry Bar
  8. Spade bit, ½ inch
  9. Tape measure, 25’ or more
  10. Tool box/bag big enough to hold all above tools

Additional Notes:

  • Level 4 (Entry) workers are not expected to bring any tools
  • All workers have a standard dress code for every work site that includes work pants, plain T/polo shirt with no logos, and work boots

For more information on our levels, check out the Levels page by clicking ‘LEVELS’ below. For more information on Steady Install, please refer to the FAQ section or contact us!